Operation CHARM: Car repair manuals for everyone.
Home >> Toyota >> 2011 >> Camry L4-2.5L (2AR-FE) >> Repair and Diagnosis >> Transmission and Drivetrain >> Manual Transmission/Transaxle >> Service and Repair >> Overhaul >> Differential Case >> Reassembly
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Reassembly





EB62 MANUAL TRANSAXLE: DIFFERENTIAL CASE: REASSEMBLY

1. INSTALL FRONT DIFFERENTIAL SIDE GEAR

(a) Coat the contact surfaces of the front differential side gears with gear oil.

(b) Install the 2 front No. 1 differential side gear thrust washers to the 2 front differential side gears.

(c) Install the 2 front differential side gears, 2 front differential pinions, and 2 front differential pinion thrust washers to the front differential case.





HINT
While rotating the front differential side gears, install the 2 front differential pinions and 2 front differential pinion thrust washers.

2. INSTALL FRONT NO. 1 DIFFERENTIAL PINION SHAFT

(a) Coat the front No. 1 differential pinion shaft with MP grease.

(b) Install the front No. 1 differential pinion shaft to the front differential case so that the hole for the front differential pinion shaft straight pin is aligned with the hole in the front differential case.





3. INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH Differential Case

4. INSTALL FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN

(a) Using a (5 mm) pin punch and hammer, tap in the front differential pinion shaft straight pin to the front differential case.





(b) Using a chisel and hammer, stake the front differential case.





5. INSTALL FRONT DIFFERENTIAL RING GEAR

(a) Clean the contact surfaces of the front differential case and ring gear.





(b) Heat the front differential ring gear to 90 to 110°C (194 to 230°F) in boiling water.

(c) After the moisture on the ring gear has completely evaporated, quickly align the matchmarks on the ring gear and the differential case and install the ring gear to the differential case.





Text in Illustration





(d) Install the 12 bolts.

Torque : 106 Nm (1081 kgf-cm, 78 ft-lbf)
pro multis · About Operation CHARM