Installation

BRAKE CONTROL: BRAKE ACTUATOR (for ADVICS Made): INSTALLATION

1. INSTALL BRAKE ACTUATOR

(a) Install the brake actuator assembly with bracket to the body with the 3 bolts.

Torque : 19 Nm (195 kgf-cm, 14 ft-lbf)

NOTICE:
Do not damage the brake lines and wire harness.





(b) Temporarily tighten each brake tube to the correct positions of the brake actuator assembly with bracket as shown in the illustration.

HINT
* *1: To Front Wheel Cylinder RH
* *2: To Front Wheel Cylinder LH
* *3: To Rear Wheel Cylinder RH
* *4: To Rear Wheel Cylinder LH
* *5: From 1st Master Cylinder
* *6: From 2nd Master Cylinder





(c) Using a union nut wrench (10 mm), fully tighten each brake line.

without a union nut wrench - Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)

with a union nut wrench - Torque : 14 Nm (143 kgf-cm, 10 ft-lbf)





NOTICE:
* Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
* This torque value is effective when a union nut wrench is parallel to a torque wrench.

(d) Connect the actuator connector.





NOTICE:
Make sure that the connector is locked securely.

2. INSTALL RADIATOR RESERVE TANK ASSEMBLY

(a) Install the radiator reserve tank assembly.





(b) Connect the radiator reserve tank hose.





3. FILL RESERVOIR WITH BRAKE FLUID Service and Repair

4. BLEED BRAKE LINE Service and Repair

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

6. BLEED BRAKE ACTUATOR (for TMC Made with VSC) Service and Repair

7. INSPECT BRAKE FLUID LEVEL Service and Repair

8. INSPECT FOR FLUID LEAK

9. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION

HINT
Programming and Relearning

10. INSPECT ACTUATOR WITH TECHSTREAM

HINT
Brake Actuator (for ADVICS Made)