Removal

PARK ASSIST / MONITORING: TELEVISION CAMERA: REMOVAL

1. REMOVE LUGGAGE COMPARTMENT DOOR COVER

2. REMOVE LUGGAGE COMPARTMENT DOOR LOCK CYLINDER ASSEMBLY

3. REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH ASSEMBLY

4. REMOVE REAR TELEVISION CAMERA ASSEMBLY (w/o Smart Key System)

(a) Remove the 2 screws and rear television camera assembly.





5. REMOVE REAR TELEVISION CAMERA ASSEMBLY (w/ Smart Key System)

(a) Disengage the 3 clamps, 3 guides and wire harness.





(b) Disengage the clamp and wire harness.





(c) Separate the cushion tape enough to allow the connector to be disconnected.

NOTICE:
The cushion tape will be reused, so be careful not to damage it during removal.

(d) Insert a 0.9 mm (0.0354 in.) spark plug gap gauge or similar tool to the side of the claw engagement portion as shown in the illustration, tilt up the claw on the connector and disconnect the camera connector.





NOTICE:
* Insert the gauge enough so that the claw becomes the same height as the protrusion of the connector housing. If the gauge is inserted too far, or if the notch on the claw is lifted directly using a screwdriver, the claw may be damaged.
* When the claw on the connector is damaged, replace the luggage door opening switch assembly.

(e) Remove the 2 screws and rear television camera assembly.