Installation

SUPPLEMENTAL RESTRAINT SYSTEM: DRIVER SIDE KNEE AIRBAG ASSEMBLY: INSTALLATION

1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

(a) Check that the ignition switch is off.

(b) Check that the battery negative (-) cable is disconnected.

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

(c) Temporarily install the driver side knee airbag assembly with the 2 hooks.





(d) Engage the 2 claws and install the DLC 3 connector.

(e) Install the driver side knee airbag assembly with the 4 bolts.





Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(f) Connect the driver side knee airbag connector.

NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH Installation

3. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation

4. INSTALL FRONT DOOR SCUFF PLATE LH Installation

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

6. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System for TMC made, Diagnosis System except TMC made).