Installation

BRAKE CONTROL: YAW RATE AND ACCELERATION SENSOR (w/ VSC): INSTALLATION

1. INSTALL YAW RATE AND ACCELERATION SENSOR (for BOSCH Made)

(a) Install the yaw rate and acceleration sensor to the bracket with the 2 nuts.

Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)





2. INSTALL YAW RATE AND ACCELERATION SENSOR

(a) Install the yaw rate sensor and acceleration with the 2 bolts.

NOTICE:
* Do not damage the yaw rate and acceleration sensor.
* Make sure that the yaw rate and acceleration sensor is installed securely.

Torque : 13 Nm (133 kgf-cm, 10 ft-lbf)





(b) Connect the yaw rate and acceleration sensor connector.

3. INSTALL NO. 1 CONSOLE BOX DUCT (for Automatic Air Conditioning System) Installation

4. INSTALL CONSOLE BOX ASSEMBLY (for Automatic Air Conditioning System)

* for TMC Made: Installation

* for TMMK Made: Installation

5. INSTALL CONSOLE BOX CARPET (for Automatic Air Conditioning System) Installation

6. INSTALL CONSOLE BOX POCKET (for Automatic Air Conditioning System) Installation

7. INSTALL UPPER REAR CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transaxle) Installation

8. INSTALL UPPER REAR CONSOLE PANEL SUB-ASSEMBLY (for Manual Transaxle) Installation

9. INSTALL UPPER CONSOLE PANEL (for Manual Transaxle) Installation

10. INSTALL FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY Installation

11. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation

12. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation

13. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) Installation

14. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle) Installation

15. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION

HINT
for ADVICS Programming and Relearning

16. INSPECT SENSOR SIGNAL

HINT
* for BOSCH Test Mode Procedure
* for ADVICS Test Mode Procedure