Installation

EXTERIOR: FRONT BUMPER: INSTALLATION

1. INSTALL FRONT BUMPER ASSEMBLY

(a) w/ Fog Light:

(1) Connect each connector.

(b) Engage the 2 claws.





(c) Install the front bumper assembly with the 8 screws, 2 clips, 2 radiator grille protectors and bolt.





(d) Install the pin hold clip.





NOTICE:
Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is vertically.

HINT
Use the same procedure for the RH side and LH side.

(e) Remove the applied protective tape on front bumper assembly.





2. INSTALL COOL AIR INTAKE DUCT SEAL (for 2GR-FE)

(a) Install the cool air intake duct seal with the 7 clips.





3. VEHICLE PREPARATION FOR FOG LIGHT AIMING (w/ Fog Light) Adjustments

4. PREPARATION FOR FOG LIGHT AIMING (w/ Fog Light) Adjustments

5. INSPECT FOG LIGHT AIMING (w/ Fog Light) Adjustments

6. ADJUST FOG LIGHT AIMING (w/ Fog Light) Adjustments